Boiler repair in Hastings-Sunrise typically costs $250-$1,800, with most calls landing near $400-$900 once the failed part is identified.
Tell us what you need—we’ll call you back fast.
Quick answer
Repairing a gas boiler in Hastings-Sunrise, East Vancouver generally runs $250-$1,800, most commonly $400-$900. These are ballpark figures pulled from 2026 public market data across the Lower Mainland, not a fixed quote — the CANRO office sends a certified gas technician to confirm the real number after a short in-person assessment. A diagnostic visit is $90-$150, credited toward the repair, with labour billed at $95-$165 an hour.
Need a licensed gas fitter for your gas boiler? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
The spread in boiler repair pricing comes almost entirely from which part has failed, not from the size of the house. A stuck zone valve or worn igniter is a quick, inexpensive fix. A failing gas valve or control board takes longer and costs more in parts, which is why two 'boiler repairs' on similar-aged systems can land at very different points on the same $250-$1,800 scale.
| Part or issue | Typical installed cost |
|---|---|
| Igniter or flame sensor | $100-$400 |
| Zone valve | $300-$650 |
| Circulator pump | $300-$1,100 |
| Expansion tank | $200-$800 |
| Gas valve | $200-$1,100 |
| Control board | $570-$1,040 |
Hastings-Sunrise sits on relatively flat ground between Hastings Street and the container terminals along Burrard Inlet, close to the PNE grounds, and the housing stock here is mostly narrow-lot character homes built from the 1910s through the 1950s. A lot of these houses have basement suites added over the decades, and boilers that were originally sized and zoned for a single household sometimes end up feeding an awkward mix of original radiators and later additions, with piping runs that have been rerouted more than once. That layered history means more potential points of failure — an extra zone valve here, a rerouted line there — than a boiler installed fresh into a newer, purpose-built system.
A number of these homes also still use older masonry chimneys for venting, sometimes shared with a fireplace flue, and a technician checks that path during any repair visit that touches the venting side of the system, since a marginal chimney can contribute to nuisance shutdowns that look like a boiler fault but actually trace back to draft issues.
The $90-$150 diagnostic fee covers real testing — gas pressure, ignition sequence, flue draft, and control readings — rather than a guess. It's credited toward the repair if you go ahead, so there's no double charge.
Under roughly twelve to fifteen years old, repairing a specific failed part is almost always the sensible move — individual components are a fraction of a full replacement's cost. Past that age, especially with a heat exchanger issue or a third or fourth repair call in a couple of years, it's worth asking for a straightforward comparison between continuing to repair and replacing the unit outright.
Safety note
If you ever smell gas, hear hissing near the appliance, or suspect a flue is spilling exhaust into the house, leave the home immediately and call FortisBC's emergency line at 1-800-663-9911 from outside — do not attempt to relight or troubleshoot the unit yourself.
Pricing tracks the specific part involved — a gas valve or control board replacement costs considerably more than a simple igniter swap, even on boilers of similar age.
It can, since a boiler zoned to serve both the main house and a suite sometimes has more valves and piping to check than a single-zone system.
It's not refunded, but it's credited toward the repair cost if you proceed, and it still covers the technician's time to properly identify the issue either way.
It needs to be evaluated for adequate draft and current venting code; a technician checks this as part of any repair that could be linked to venting.
There's no fixed number, but once a boiler passes fifteen years and needs several repairs in a short span, replacement usually becomes the more practical option.
Financing options exist and change over time; ask the CANRO office about current options rather than assuming specific terms.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.