Daikin Furnace Installation in Vancouver

Need a licensed gas fitter for your gas furnace? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.

When replacement makes more sense than another repair

The usual signals are a cracked or corroded heat exchanger, a furnace that's needed several unrelated repairs in a short stretch, rising discomfort or uneven heating that a repair hasn't fixed, and a unit that's well into its second decade of service where individual parts are becoming harder to source quickly. None of those are hard rules — a well-maintained furnace can run longer, and a newer one can fail early — but they're the pattern CANRO looks for before recommending replacement over another repair.

Sizing for Vancouver's existing ductwork

A lot of the installation work in Vancouver isn't a brand-new build, it's swapping a furnace into ductwork that was sized decades ago for a different unit. That's where a proper heat-loss assessment earns its keep: an oversized furnace short-cycles and never really settles into steady, even heat, while an undersized one runs constantly and still can't keep up on a cold snap. CANRO measures the home rather than defaulting to 'replace like for like,' because the original furnace may not have been sized correctly in the first place, especially in homes that have added insulation, replaced windows, or finished a basement since the ductwork was installed.

Vancouver's mix of housing stock adds its own wrinkle. Pre-war character homes often had forced air retrofitted into a house that was never designed for ducting, which means the duct runs can be tighter and less direct than a home built with forced air in mind. Vancouver Specials, common through the city's east side and beyond, typically have more straightforward basement mechanical rooms but often carry a finished or rented basement suite that limits where noise and clearance are acceptable.

What the install day looks like

1. Disconnect and remove the old furnace, capping gas and electrical safely.
2. Confirm or modify venting to match the new furnace's exhaust category — this is where a lot of the real work happens on an older home.
3. Set and level the new furnace, connect ductwork, gas line and electrical.
4. Commission the unit: verify gas pressure, airflow, and safety switch operation before it's called done.
5. Walk through the thermostat and basic operation with you before the technician leaves.

Venting is usually the step that determines whether an install finishes in a few hours or stretches into a longer day. A furnace that's the same efficiency tier as the old one, venting through an existing flue, is straightforward. A jump to a different venting category, or a flue that needs upgrading for code reasons, adds time and cost that a phone quote can't responsibly predict.

Cost and what actually moves it

$4,500 to $9,500+ is the ballpark, not a quote — the office confirms an actual price after looking at your specific job. Venting changes, gas line modifications, ductwork repairs or extensions, and access (a furnace in a cramped crawlspace costs more labour than one in an open basement) are the main variables. Two homes with the same new furnace can land at very different points in that range depending on what's already in place.

Permits and the City of Vancouver

Vancouver operates under its own building bylaw rather than defaulting entirely to the code most other Metro Vancouver municipalities use, and gas furnace installation requires permits through the city before work is signed off. Any gas line work has to be done by a Technical Safety BC licensed gas fitter regardless of which municipality you're in, but the permit and inspection process itself runs through Vancouver's own building department. CANRO handles the permit application as part of the installation rather than leaving that step to the homeowner.

Frequently asked questions