KeepRite furnaces show up often in Vancouver's rental suites and older multi-unit conversions, and CANRO diagnoses them with the same careful process as any brand.
Tell us what you need—we’ll call you back fast.
Quick answer
KeepRite is distributed widely across Canada through independent HVAC dealer networks, and it's a common find in Vancouver's basement suites and older rental conversions. Most repair calls come down to one of a handful of categories: ignition failure, a restricted or dirty flame sensor, a blower or inducer motor issue, or a control board that's stopped responding correctly to the thermostat. A CANRO technician narrows the category through direct testing rather than swapping parts on a guess, which keeps the repair focused on the actual fault.
Need a licensed gas fitter for your gas furnace? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
KeepRite's value positioning and wide independent-dealer distribution have made it a common choice for rental properties and older multi-unit conversions — the kind of triplex-in-a-house-shell buildings scattered through parts of East Vancouver and the Kingsway corridor, and basement suites throughout the city more broadly. That context matters for repair calls, since a furnace serving a tenant means downtime has a real cost for the landlord and real discomfort for the person living there, which shapes how quickly a diagnosis needs to happen and how clearly the options get explained.
| What you're noticing | Likely category |
|---|---|
| Furnace tries to light, then shuts down | Ignition — igniter, flame sensor, or gas valve issue |
| Blower runs constantly or won't shut off | Fan control setting, or a limit switch stuck from restricted airflow |
| No response at all when the thermostat calls for heat | Power supply, blown control fuse, or a safety switch already tripped |
| Loud grinding or squealing on startup | Blower motor bearing wear or a failing inducer motor |
Past that, opening the cabinet to test ignition components, the gas valve, or the control board is technician work. It's not just a safety line we draw for liability — testing these correctly requires a meter and knowledge of the expected values, and guessing wrong can turn a simple repair into a bigger one.
A technician starts with the symptom pattern you describe on the phone, then confirms it on site before opening anything up. From there it's methodical: verify power and thermostat signal reach the board, check safety switches individually, then move into ignition testing only once airflow and safety are confirmed fine. That order matters because a furnace starved for air will refuse to fire regardless of how healthy the ignition components are, and jumping straight to replacing an igniter on that kind of call wastes the homeowner's money.
A cracked or corroded heat exchanger is always a replace, on any brand — that's not a component that gets repaired. Outside of that, the decision usually comes down to the specific part, the furnace's age, and how many unrelated repairs it's needed recently. For a rental unit, there's also a timing question: a landlord weighing a repair against replacement often factors in tenant turnover and how much disruption either option causes, and we lay out both paths honestly rather than pushing one.
Furnaces serving basement suites in Vancouver's older converted homes often sit in tight mechanical closets shared with laundry or storage, with less clearance around the cabinet than a purpose-built mechanical room would have. That affects how much room a technician has to work and occasionally means clearing space before the visit even starts. It's a small thing, but mentioning it when you book can save time on the day of the call.
Safety note
Ignition components, the gas valve, control board and venting on a gas furnace must only be diagnosed and repaired by a Technical Safety BC licensed gas fitter — CANRO holds gas licence LGA0043870. If you ever smell gas near the furnace, leave the house immediately and call FortisBC's emergency line, 1-800-663-9911, from outside.
KeepRite is positioned as a value brand with wide independent-dealer distribution across Canada. Positioning affects price point, not the diagnostic approach — CANRO repairs it with the same careful process as any other gas furnace.
Yes. Most KeepRite calls CANRO takes are on units another company originally installed, and diagnosis starts the same way regardless of the installer.
We prioritize no-heat and unsafe-sounding calls, and a loud grinding or squealing noise usually falls into that category since it often signals a motor bearing on its way out.
Often yes, if it's a single, identifiable part failure and the furnace hasn't had a string of unrelated repairs. We'll tell you plainly if the numbers stop making sense.
Usually just the mechanical closet or basement where the furnace is located, but if that space is inside a tenanted suite, arranging access in advance saves a wasted trip.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.