🛡️ Licensed & Insured · TSBC Gas-Fitting LGA0043870 · Serving Metro Vancouver since 1999
★★★★★ 4.9 from 85+ Google reviews · info@canroheat.ca
Metro Vancouver HVAC · Since 1999

Laars Boiler Not Heating in New Westminster

Why a Laars gas boiler stops heating in New Westminster's older housing stock, and what's safe to check before calling a technician.

★ 4.9/5 · 85+ reviews✅ Licensed & insured💰 Rebates & financing👨‍🔨 Since 1999

Get your free quote

Tell us what you need—we’ll call you back fast.

No obligation · We never share your info

🎉
25+ YearsServing Metro Vancouver since 1999
★
4.9 / 5 Rating85+ verified Google reviews
🛡️
Licensed & InsuredTSBC LGA0043870 · Boiler LBP0046450 · Red Seal · WorkSafeBC
💵
Rebates HandledCurrent BC programs—eligibility checked before installation

Quick answer

A Laars gas boiler that's stopped heating in a New Westminster home is usually caused by a thermostat or control fault, an ignition or flame-sensing issue, low system pressure, or trapped air and leaks in an original cast-iron radiator loop common in the city's older housing. A homeowner can safely check the thermostat, breaker, pressure gauge, and whether radiators are cold at the top, but the burner, gas line, and internal controls need a Technical Safety BC licensed gas fitter. Because New Westminster has more heritage and early-20th-century homes than most nearby cities, no-heat calls here trace back to the piping loop more often than in newer housing stock.

Need a licensed gas fitter for your gas boiler? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.

Safe Checks to Run First

  • Confirm the thermostat is set to heat and calling for a warmer temperature than the room currently is
  • Check the electrical panel for a tripped breaker
  • Look at the pressure gauge and compare it to the normal operating range near the dial
  • Feel radiators throughout the house; cold at the top but warm at the bottom usually means trapped air, not a boiler fault

What Usually Causes No Heat on a Residential Boiler

Once the basics are ruled out, the cause typically falls into a few categories.

  • An ignition or flame-sensing fault stopping the burner from lighting or holding a flame
  • Low system water pressure, often from a slow leak somewhere in the piping
  • Trapped air in the radiator loop, particularly common on older cast-iron systems
  • A circulator pump that's worn out and no longer moving water effectively
  • A control board or aquastat fault interrupting the call for heat
  • A stuck zone valve, on homes with a system divided into multiple zones

Why Older Homes Here See a Different Pattern

New Westminster's concentration of heritage and early-20th-century housing, especially around Queens Park, means a lot of homes still run original cast-iron radiators tied into a boiler that may have been replaced more recently than the piping around it. On these systems, no-heat or partial-heat problems trace back to the loop itself surprisingly often: trapped air causing cold spots, a slow leak at an old fitting dropping system pressure, or sediment that's settled in older sections of pipe restricting flow.

The city's steep streets also mean many mechanical rooms sit below grade with limited access and sometimes damp corners, which can accelerate corrosion at exposed fittings near the boiler over the years. A technician diagnosing no heat in one of these homes checks the loop and radiators as carefully as the boiler itself, rather than assuming the newer equipment is automatically the problem.

Emergency Versus Routine Situations

SituationWhat To Do
Gas smell near the boilerLeave the home immediately and call FortisBC from a safe location
Carbon monoxide alarm soundingLeave the home immediately and call FortisBC from a safe location
Whole house cold, no smell, no alarmRun through the safe checks, then book a diagnostic visit
Some radiators cold, others warmNot an emergency; try bleeding the cold radiators first

What a No-Heat Diagnostic Visit Involves

A licensed gas fitter starts by confirming the boiler itself is firing and producing heat, then checks whether the problem is isolated to specific radiators or zones versus affecting the whole home. On an older New Westminster property, that often means tracing pressure loss or flow restriction through the original piping loop, not just checking the boiler's own components.

Safety note

If you smell gas near the boiler or your carbon monoxide alarm sounds, leave the home immediately and call FortisBC at 1-800-663-9911 once everyone is safely outside. Diagnosing or repairing a boiler's burner, gas supply, or venting, including chimney-vented systems common in older New Westminster homes, must be done by a Technical Safety BC licensed gas fitter.

Frequently asked questions

My radiators are cold at the top. Is my boiler broken?

Probably not. Cold tops on a radiator almost always mean trapped air, which is common on older cast-iron systems and usually resolved by bleeding the radiator. If it happens repeatedly, it's worth having a technician check the loop for a slow leak feeding air into the system.

Why would an old piping loop cause a no-heat problem instead of the boiler?

Original piping and fittings in New Westminster's heritage homes are often decades older than the boiler itself, and issues like slow leaks, trapped air, or settled sediment in the loop can cause pressure loss or restricted flow that looks like a boiler fault but isn't.

What should I check before calling for repair?

Confirm the thermostat is calling for heat, check the breaker, look at the pressure gauge, and feel your radiators to see if some are cold while others are warm. That last detail helps narrow down whether the issue is the boiler or the loop.

Is my home's original chimney venting still safe?

That depends on the chimney's current condition and liner, which is something a licensed technician evaluates as part of diagnosing venting-related issues. Older masonry liners can deteriorate over decades, so this is worth checking rather than assuming.

How is a no-heat diagnosis different on an older home versus a newer one?

On a newer home, the boiler and its immediate controls are usually the first place to look. On an older New Westminster home, the piping loop and radiators often get equal attention, since problems there are at least as common as anything wrong with the boiler itself.

Related CANRO pages

Talk to a licensed CANRO gas fitter

Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.

Call (604) 359-1081 Email info@canroheat.ca
Good to know

Frequently asked questions

How often should a boiler be serviced?
Annual servicing is recommended for all residential boilers. CANRO's annual service includes combustion analysis, heat exchanger inspection, expansion tank pressure check, condensate trap cleaning, and a full safety check. Annual maintenance is also required to keep most manufacturer warranties valid.
How much does a new boiler cost in Vancouver?
A typical residential high-efficiency gas boiler in Metro Vancouver costs $7,500–$15,000 installed, depending on size, brand, and whether the system is heating only or a combi unit that also handles hot water. CANRO provides a free written quote with three options at different price points.
How long does a boiler last?
A well-maintained cast-iron boiler can last 25–30 years, a modern high-efficiency condensing boiler typically lasts 15–20 years, and a combi boiler 12–18 years. Annual servicing has the single biggest impact on lifespan.
My boiler is making a banging or kettling noise. Is that dangerous?
Kettling (a banging or whistling sound) is usually caused by limescale build-up on the heat exchanger and is a sign the system is overheating in localised spots. It will not always cause immediate failure but it shortens the life of the boiler and should be addressed within a few weeks.
Do you service Viessmann, IBC, Baxi, Laars, and Weil-McLain boilers?
Yes. CANRO is one of the few HVAC companies in the Lower Mainland with deep experience on European and high-end North American boilers including Viessmann, IBC, Baxi, Laars, Weil-McLain, NTI, Navien and Rinnai. We carry common parts in the truck.
Should I repair or replace my old boiler?
A useful rule: if the boiler is more than 15 years old and the repair cost is more than 50% of replacement, replacement is the better investment. CANRO will give you both a repair quote and a replacement quote and let you decide.
What HVAC services does CANRO offer in Metro Vancouver?
CANRO installs, services and repairs boilers, furnaces, heat pumps, hot water tanks, tankless water heaters, gas fireplaces and air conditioning across Metro Vancouver. We work on residential homes, townhouses and condos throughout the Lower Mainland.
How long has CANRO been in business?
CANRO has been serving the Greater Vancouver area since 1999. Our founder George is recognised by customers as one of the most experienced boiler and hydronic heating technicians in the Lower Mainland.
What areas do you serve?
We cover all of Metro Vancouver: Vancouver, Burnaby, Richmond, Surrey, Coquitlam, North Vancouver, West Vancouver, New Westminster, Delta, Langley, Port Moody, Port Coquitlam, White Rock, Pitt Meadows, and Maple Ridge.
Keep reading

Related laars boilers articles

Reviews

What Metro Vancouver homeowners say

4.9
★★★★★
85+ verified Google reviews
★★★★★

“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”

Nadia Naderi
Nadia NaderiGoogle review
★★★★★

“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”

Arlene Colasurdo
Arlene ColasurdoGoogle review
★★★★★

“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”

B. Niek
B. NiekGoogle review

Need heat, hot water or cooling? Talk to a real technician today.

25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.

📞 Call (604) 359-1081 Get a free quote →
📞 Call nowFree quote