What replacing a Noritz EZTR condensing tankless unit involves for a White Rock home, whether it sits near the water or up on the bluff.
Tell us what you need—we’ll call you back fast.
Quick answer
In White Rock, replacement is usually triggered by a corroded or leaking heat exchanger, sometimes sooner on beach-level properties because of coastal exposure, or by repeated unrelated repairs on an older unit anywhere in town. The install process itself is standard once venting route and gas line capacity are confirmed.
Need a licensed gas fitter for your tankless water heater? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
White Rock's small footprint hides a real difference in exposure depending on elevation. Homes down near the promenade deal with more persistent salt air, which can shorten the practical life of exposed vent fittings compared to a similar unit set back on the bluff above. That's a genuine factor in deciding when to replace rather than repair one more time, separate from the unit's calendar age.
Bluff-top homes, being newer on average and further from direct coastal exposure, tend to follow a more typical replacement timeline driven by ordinary component wear rather than environmental corrosion.
A heat exchanger with visible corrosion or a leak is the clearest signal, and it's more common to see this earlier on a beach-level property than elsewhere in the region. Beyond that, the usual pattern applies everywhere: several unrelated component failures in a short window, or recovery performance that stays sluggish even after descaling, both point toward planning a replacement rather than continuing to repair.
On a beach-level property, the assessment pays particular attention to vent termination placement and fitting material given ongoing salt-air exposure. On a bluff-top property, the focus shifts more toward confirming gas line capacity and standard venting route, similar to most suburban installs in the region. Either way, a permit through the City of White Rock is required for the gas connection work, and CANRO applies for it as part of the project.
White Rock is its own small municipality wedged into a bigger surrounding area, and its building department can have its own scheduling rhythm separate from neighbouring jurisdictions. That's simply something we plan around when timing an install, rather than a hurdle that changes what the job itself involves.
Since the EZTR series is built to occupy roughly the space a storage tank used to take up, the physical swap is usually straightforward. Sizing still gets checked against how the household actually uses hot water — number of bathrooms, whether there's a secondary suite, and how often fixtures run together. On install day, the old unit is removed, the new unit mounted and connected, venting and condensate drainage run and tested, gas pressure verified, and the system commissioned before the crew signs off.
Before the crew leaves, someone walks you through the basics of the new unit — where the isolation valves are, what a normal startup sounds like, and who to call if something seems off in the first few weeks of use.
Based on current public-market pricing for the region, a tankless install typically runs $3,500 to $7,500 depending on the unit, venting work, and any gas line changes needed. That's a ballpark drawn from 2026 market data, not a quote — CANRO's certified technicians confirm the actual number after assessing your specific property.
Safety note
Gas piping and venting work on a tankless installation must be performed by a Technical Safety BC licensed gas fitter — CANRO holds gas licence LGA0043870 — and typically requires a City of White Rock permit. If you ever smell gas near an appliance, leave the house immediately and call FortisBC at 1-800-663-9911.
It can, mainly because of accelerated corrosion on exposed fittings rather than anything about the unit's core performance. It's one factor among several a technician weighs.
Installation choices like fitting material and termination placement help manage the exposure, but there's no way to fully eliminate the effect of ongoing coastal air over many years.
Yes, since it involves gas connection work. CANRO handles the City of White Rock permit application as part of the job.
A straightforward swap is typically a single day; jobs needing venting changes take longer, and that's scoped honestly at the assessment stage.
Within code and venting requirements, yes — your technician will discuss options if you'd prefer a different location than the old unit occupied.
It's removed and disposed of as part of the installation, so you don't need to arrange that separately.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”

“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”

“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”

25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.