Licensed, Red Seal technicians — same-day response across Metro Vancouver. Call (604) 359-1081 or request a free quote.
Tell us what you need—we’ll call you back fast.
If you are considering heat pumps, this guide walks through the key technical and practical points specific to Metro Vancouver. A cold-climate heat pump in Metro Vancouver delivers 2-4 units of heat per unit of electricity — meaning 200-400% effective efficiency vs 95-98% for the best gas furnace. Vancouver's mild winters (rare lows below -5°C) are ideal heat-pump territory.
Vancouver's moderately hard tap water (around 60-100 ppm hardness in most of Metro Vancouver) affects tankless water heaters, combi boilers, and hot-water tanks — annual descaling is essential. CANRO has worked with heat pump systems across Metro Vancouver since 1999, including installations and service calls in Thompson, Norgate, Brentwood and Yaletown.
Sizing. Heat-pump sizing balances heating capacity at design temperature (often -10°C in Metro Van) against cooling load. Variable-capacity units handle both ends well — over-sizing for heating causes summer humidity problems.
Lifespan. A modern heat pump installed by a qualified contractor typically lasts 15-20 years. Annual maintenance, regular filter changes, and keeping the outdoor coil clear of leaves and debris all extend service life.
Warning signs. Heat-pump issues include short-cycling, refrigerant-charge problems (low cooling capacity), defrost-cycle faults, communicating-system errors, and ECM motor failures at 12+ years.
Yes. Modern cold-climate heat pumps from Mitsubishi (H2i), Daikin (Aurora), Carrier (Greenspeed) and Lennox (XP25) maintain rated heating capacity down to -15°C and continue producing heat (at reduced capacity) down to -25°C — far colder than Metro Vancouver ever gets.
If you already have ductwork from a furnace, a ducted central heat pump is usually the better choice for whole-home comfort. Ductless mini-splits are ideal for additions, basement suites, garage conversions, and homes without ducts (radiant-heated houses).
A whole-home ducted heat pump installation in Metro Vancouver typically costs $13,000-$22,000 before rebates. After stacking BC Hydro + FortisBC + federal rebates, eligible homeowners can see net costs of $5,000-$11,000.
Yes — every heat pump is also a fully functioning air conditioner. One unit replaces both a furnace and an A/C, saves floor space, and qualifies for rebates that a separate A/C alone would not.
SEER measures cooling efficiency (higher is better, 16-22 typical); HSPF and the newer HSPF2 measure heating efficiency. For Vancouver, look for HSPF2 above 9.0 — that's the threshold for premium cold-climate performance and most rebate programs.
Current heat-pump rebates can total $11,000+ for eligible Vancouver homeowners: up to $6,000 from CleanBC, up to $5,000 from federal Greener Homes, plus income-qualified top-ups. CANRO is a registered contractor and handles the paperwork end-to-end.
To book heat pump service or get a free written quote for installation, call CANRO at (604) 359-1081 or email info@canroheat.ca. We service all of Metro Vancouver including Thompson, Norgate, Brentwood and Yaletown.
This guide was written by the CANRO Heating & Cooling team based on 25+ years of heat pump installation, repair and annual service work across Metro Vancouver. Last reviewed May 2026.
“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.