1 Lennox HVAC Company in Greater Vancouver – CANRO Heating & Cooling

Expert insights: Lennox central A/Cs in Metro Vancouver

Selecting and servicing central A/Cs in Metro Vancouver involves several local factors — climate, available rebates, code requirements — covered below. Lennox is American (Iowa, 1895), best known for its SLP99V variable-capacity gas furnace (up to 99% AFUE) and the XC25 air conditioner. The brand's strengths are industry-leading variable-capacity modulation, premium build quality, top-rated for quiet operation.

Metro Vancouver's coastal climate brings salt-laden air to coastal neighbourhoods (Steveston, Tsawwassen, White Rock) that accelerates outdoor coil corrosion — an important factor in equipment selection and placement. CANRO has worked with Lennox systems across Metro Vancouver since 1999, from older retrofits in Cloverdale and Westwood Plateau to new builds in Burnaby Heights and Westwood Plateau. Lennox is generally a strong fit for mid-to-upper Vancouver homes wanting maximum efficiency and the quietest possible system.

Technical considerations for central A/Cs in Metro Vancouver

Sizing. A/C sizing in Vancouver is typically 1 ton per 600-1,000 square feet depending on insulation, windows, and orientation. Over-sized A/C is the most common error — it leads to short-cycling, poor dehumidification, and premature compressor failure.

Lifespan. A properly maintained central A/C unit lasts 12-15 years. Vancouver's coastal salt air shortens outdoor-coil life — annual coil cleaning is more important here than inland.

Warning signs. A/C issues include warm air from supply registers, water leaks from the indoor coil (clogged condensate drain), refrigerant odour (R-410A leak), and noisy compressor startup.

Common Lennox central A/C issues CANRO diagnoses

Over 25+ years of Lennox service calls across Metro Vancouver, the recurring issues we see are: flame-sensor fouling on older units, control-board failures on iComfort thermostats, blower-wheel ECM motor failures.

Parts availability. Lennox parts are dealer-network only — independent shops often struggle to source within 48 hours, but CANRO maintains a Lennox parts pipeline.

What CANRO checks during a central A/C service

• Refrigerant charge measurement
• Outdoor coil clean
• Indoor evaporator coil inspection
• Capacitor microfarad test
• Contactor inspection
• Condensate drain and pan inspection
• Blower motor amp draw
• Filter check and airflow measurement
• Thermostat operation test

Why Metro Vancouver homeowners choose CANRO for central A/C work

• Founded 1999 — over 25 years of central air conditioning installations and service calls in Metro Vancouver
• 4.9-star rating from 85+ verified Google reviews
• Direct workers, no subcontractors — the tech who installs your system is the one who answers when you call back
• Free written estimates on installations; transparent diagnostic fee on repairs (credited toward the repair if you proceed)
• TSBC-licensed gas fitter, Red Seal HVAC, WorkSafeBC and liability insured
• Permits filed and inspected on every gas-appliance install (BC Code-compliant)
• Brand specialist coverage: Viessmann, IBC, Baxi, Laars, Weil-McLain, Navien, Rinnai, Bradford White, Carrier, Lennox, Bryant, Goodman, Mitsubishi, Daikin, Bosch and more

Lennox Central a/c FAQs

What size A/C does my Vancouver (Lennox) home need?

A/C sizing in Vancouver is typically 1 ton (12,000 BTU) per 600-1,000 sq ft depending on insulation, windows, and orientation. Over-sized A/C is the most common error — it short-cycles, dehumidifies poorly, and shortens compressor life.

Will R-410A refrigerant be available for my A/C in 5 years?

R-410A is being phased down (not phased out) under EPA AIM rules. Existing R-410A systems can continue to be serviced — refrigerant remains available for the foreseeable future, though prices may rise. New systems installed 2025+ increasingly use R-32 or R-454B with lower global-warming potential.

Why does my A/C leak water inside the house?

Indoor water leaks from central A/C indicate a clogged condensate drain (most common), a failed condensate pump on attic installs, a frozen evaporator coil thawing, or a damaged drain pan. All are repairable in a single service visit.

Do I really need air conditioning in Vancouver (Lennox)?

Vancouver summers have been getting hotter — the 2021 heat dome saw temperatures over 40°C. Most modern Vancouver homes now install a heat pump (heating + cooling in one) rather than a stand-alone A/C, taking advantage of rebates available for heat pumps but not stand-alone A/C.

How much does central A/C cost in Metro Vancouver (Lennox)?

A typical 2.5-3 ton central A/C added to an existing forced-air furnace costs $5,500-$9,500 installed. A heat-pump conversion (cooling + heating in one unit) is usually a smarter long-term investment given available rebates.

How often should A/C be serviced?

Annual servicing in spring keeps the outdoor coil clean, the refrigerant charge correct, and the indoor evaporator coil and condensate drain clear. Skipping service is the single biggest cause of premature compressor failure.

Book Lennox central A/C service in Metro Vancouver

To book Lennox central A/C service or get a free written quote for installation, call CANRO at (604) 359-1081 or email info@canroheat.ca. We service all of Metro Vancouver including Cloverdale, Westwood Plateau, Burnaby Heights and Westwood Plateau.

This guide was written by the CANRO Heating & Cooling team based on 25+ years of central A/C installation, repair and annual service work across Metro Vancouver. Last reviewed May 2026.