Burnaby's patchwork of building eras, from Capitol Hill character homes to newer Metrotown-area builds, is the main reason installation costs vary here.
Tell us what you need—we’ll call you back fast.
Quick answer
As a 2026 ballpark, not a quote, a Bosch boiler installed in a Burnaby home generally runs $6,500 to $14,000 or more, with the specific number shaped by the age of the house and how much of the existing venting and gas line can be reused. CANRO is based in Burnaby, and our certified gas technicians confirm the actual figure for your home after an in-person assessment.
Need a licensed gas fitter for your gas boiler? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
Burnaby packs a lot of different building eras into a relatively compact city. A character home up around Capitol Hill or Burnaby Heights, some dating to the early twentieth century, often has a boiler room built around an old masonry chimney that predates sealed-combustion venting requirements. A newer townhome complex near Metrotown or Brentwood, by contrast, was typically built with a mechanical closet already sized for modern equipment, which usually means a more straightforward Bosch installation with less venting rework.
Deer Lake and the areas around it have their own mix of larger, older single-family lots that sometimes still run original hydronic systems installed decades ago, which is where a lot of full-replacement work in the city tends to happen rather than straightforward new installations.
| Item | Ballpark (2026) | Notes |
|---|---|---|
| Bosch boiler installed, typical range | $6,500–$14,000+ | Older character-home venting reworks trend toward the top of the range |
| Full replacement including old boiler removal | $7,500–$15,000+ | Common in Burnaby's older single-family neighbourhoods |
| City of Burnaby gas permit | $75–$200 | Set by the municipality |
| Labour, where venting or gas line work applies | $95–$165 per hour | Older homes with masonry chimneys often need more hours |
In Burnaby's older neighbourhoods, it's common to find boilers that have had multiple repairs over the years without ever being fully replaced. If a technician is looking at a repair on a unit that's already had two or three unrelated component failures, that pattern — more than the age number on its own — is usually the better signal that replacement will save money over the next few years compared with continuing to repair piece by piece.
The City of Burnaby requires its own gas permit and inspection for any new boiler installation. Being based in Burnaby ourselves means CANRO's technicians see this specific mix of housing stock regularly, from older Capitol Hill character homes to newer Brentwood-area builds, which helps in planning the vent path and gas line work correctly before the job starts rather than discovering surprises partway through.
Safety note
A gas boiler is a combustion appliance, so any smell of gas, soot near the vent terminal, or a triggered CO alarm means you evacuate first and call FortisBC's emergency line, 1-800-663-9911, from outside the home. Never try to diagnose a suspected leak or venting fault on your own.
Not always, but homes with an original masonry chimney and older gas lines more often need venting rework and line upsizing than a newer build, which typically pushes the cost toward the higher end of the range.
It's a standard municipal gas permit process; your licensed installer pulls it as part of the job, and it should already be included in your quote.
Multiple unrelated repairs on the same aging unit is a good reason to ask your technician for a direct comparison against replacement cost rather than approving another one-off repair.
Generally yes, since mechanical closets in newer builds are more often already sized and vented appropriately for a modern condensing boiler, though every property still needs its own assessment.
Yes, CANRO is based in Burnaby and has served Metro Vancouver homeowners since 1999, which means our technicians are familiar with the city's mix of housing eras.
A straightforward swap in an accessible mechanical room can often be completed in a day; a job needing venting rework or gas line upsizing in an older home typically takes longer.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.