A real furnace estimate in Victoria-Fraserview means a technician in your mechanical room, not a number guessed over the phone.
Tell us what you need—we’ll call you back fast.
Quick answer
A furnace estimate for a Victoria-Fraserview home is built from an in-person assessment of your existing furnace, ductwork, venting and gas supply, not a phone quote. For a straightforward gas furnace installation or replacement, homeowners can expect a ballpark of $4,500 to $9,500 or more, confirmed only after that visit. The final number depends on furnace size, venting changes and any duct or gas line work the home needs.
Need a licensed gas fitter for your gas furnace? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
Victoria-Fraserview has a lot of post-war bungalows built from the 1940s through the 1960s, many with additions, converted basements, or a secondary suite tucked underneath. A furnace that fit the original floor plan may now be undersized or oversized for the current layout, and the only way to know is for a technician to walk the mechanical room, measure the existing ductwork, and look at how the home has been altered over the decades.
A number given without seeing the house is a guess. CANRO's estimate process starts with that walkthrough: current furnace age and condition, duct sizing, return-air setup, and whether the venting run to the exterior wall or roof still meets today's clearance requirements.
For a straight swap, where the new furnace sits in the same spot, uses the existing duct trunk, and the vent termination is already compliant, pricing tends to land at the lower end of the range. Homes where the furnace has to move, where ductwork needs extending to a converted basement suite, or where the vent has to be rerouted for clearance will land higher.
The visit covers a physical inspection of the furnace, heat exchanger area, venting, and gas connection, plus a look at the thermostat wiring and duct condition. You get a written scope before any work starts: what's being replaced, what stays, and the ballpark of $4,500 to $9,500 or more for installation or replacement, confirmed after the assessment and never treated as the final invoice until the scope is locked in.
If a permit is required for the work, that gets flagged at the estimate stage too, since the City of Vancouver requires a permit for gas furnace installation and CANRO pulls it as part of the job rather than leaving it to the homeowner.
If you're gathering more than one estimate, ask each contractor the same questions: did they measure the ductwork, did they check the vent termination clearance, and does the number include the permit. A quote that skips the home visit entirely is one you should treat with caution, regardless of how competitive it looks on paper.
Safety note
If you ever smell gas near the furnace or notice a scorched or sooty smell from the vent, leave the home first and call FortisBC at 1-800-663-9911 from outside before doing anything else. Gas furnace work in BC must be done by a Technical Safety BC licensed gas fitter; CANRO holds gas licence LGA0043870.
Plan for roughly 30 to 45 minutes for the technician to inspect the furnace, ductwork, and venting, and to answer questions about the scope before leaving you a written estimate.
CANRO's estimate process is part of a scheduled visit; ask the office when you book what applies to your specific situation, since it depends on whether other work is being assessed at the same time.
The written scope will flag whether a City of Vancouver permit is needed for the installation; permit costs are separate and confirmed once the scope is finalized.
Often yes for a straight swap in an unaltered home, but if the basement has since been finished or suited, the technician will re-check sizing against the current duct layout rather than assume the old number still applies.
Older duct trunks in Victoria-Fraserview homes are usually still usable if they're intact and properly sized, but the technician will check for leaks, crushed sections, or undersized returns that could affect the new furnace's performance.
Yes, someone needs to provide access to the mechanical room and answer questions about any renovations or additions, since that history affects the sizing and scope.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.