Burnaby Heights' century-old homes along Hastings Street often still carry their original gas piping, which CANRO inspects, repairs, or replaces to code.
Tell us what you need—we’ll call you back fast.
Quick answer
Gas line installation and repair in Burnaby Heights usually means dealing with piping that dates back to when the neighbourhood's Hastings Street corridor homes were first built, some over a century ago. Work ranges from a simple appliance hookup to a full re-pipe when the original line can no longer be trusted. A licensed gas fitter inspects the existing run, plans the new work around the home's age and layout, and books the City of Burnaby permit inspection before anything is connected.
Need a licensed gas fitter for your gas water heater? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
Burnaby Heights, along the Hastings Street corridor, holds some of Burnaby's oldest housing stock, with homes dating back to the 1910s and 1920s sitting alongside mid-century infill and newer construction. That age range means gas line condition varies enormously from one house to the next, even on the same block.
A home built in the 1910s may have gone through several rounds of piping changes over the decades: an original low-pressure run, a mid-century upgrade when the furnace was replaced, and possibly a partial repair done without a permit at some point. Sorting out what's actually there is often the first real task on a Burnaby Heights job.
The Heights sits on a slope running down toward Burrard Inlet, and older homes here often have shallow, partial basements or crawl spaces rather than a full modern foundation. That affects where a gas line can be routed and how much room a technician has to work with when replacing a section under the house.
Where a line needs to reach a detached garage or a rear addition on a sloped Burnaby Heights lot, the grade itself factors into how deep the buried run needs to sit and how it's protected where the slope changes.
Burnaby's permit office requires a gas permit for new installation and most repairs, with a final inspection before the line is approved for use. For a home with undocumented past work, this inspection is also the point where any old, non-compliant piping gets flagged and corrected as part of the current job rather than left as a hidden liability for a future owner.
A technician starts by tracing the existing line as far as it's accessible, noting its age, material, and condition, before recommending a targeted repair or a fuller re-pipe. The goal is to match the scope to what the house actually needs: not every century-old line requires full replacement, but every one deserves an honest assessment before a repair is proposed.
Working on gas piping that predates most current code requirements takes more than general handyman skill. CANRO's technicians hold a Technical Safety BC gas licence, LGA0043870, and the company has been working on Metro Vancouver homes, including plenty in Burnaby Heights, since 1999, long enough to have seen most of the ways early-1900s piping was originally run and later patched.
Before any work starts on a Heights property, you get a clear explanation of what was found in the existing line and what the recommended fix actually involves, so you're deciding on a documented assessment rather than a guess. Final pricing is confirmed by the office after that assessment, not before it.
Safety note
Treat any gas odour as an emergency, not a maintenance item: evacuate first, then call FortisBC at 1-800-663-9911 from next door or from the street. Do not try to locate or fix the leak yourself.
If you don't have records, a technician can often tell from the materials and routing whether work looks original, professionally updated, or informally patched, and will flag anything that can't be verified as compliant.
It limits access more than it limits what's possible; a technician plans the work around the available clearance, which can affect how long a job takes rather than what can ultimately be done.
Often yes, if the rest of the run pressure-tests sound; a targeted repair is common when the problem is localized rather than affecting the entire piping run.
Yes, the slope affects burial depth and protection where the grade changes, which a technician accounts for when routing a new line to a detached structure.
Don't assume it's inert. Have a licensed gas fitter confirm it's properly capped and out of service rather than leaving it unverified.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.