Deer Lake's deep, forested lots and larger character homes mean gas line runs often stretch farther than on a standard Burnaby block.
Tell us what you need—we’ll call you back fast.
Quick answer
Around Deer Lake in Burnaby, gas line installation and repair for a furnace, boiler, tankless unit or water heater has to account for deep, tree-covered lots where the mechanical room can sit a long way from the street. A City of Burnaby gas permit, pressure test and inspection apply before startup. CANRO's licensed gas fitters measure the actual run and root layout before sizing or repairing a line on one of these larger properties.
Need a licensed gas fitter for your gas water heater? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
The area around Deer Lake Park and Burnaby Village Museum includes some of Burnaby's larger residential lots, many with mature trees, deep setbacks, and a mix of older character homes alongside newer estate-style rebuilds. A gas line here frequently has to travel farther from the meter to the mechanical room than on a standard 33-foot city lot, and often has to route around established root systems that a homeowner understandably doesn't want disturbed.
Larger character homes in this area also sometimes carry a heavier appliance load than a typical bungalow: a furnace, a separate water heater, and a gas fireplace or two are common, which adds up quickly on an older, smaller-diameter line.
A sulphur odour anywhere along the property, not just at the house itself, is the sign to act on right away.
On a deep lot, both distance and total load factor into sizing: a longer run needs a larger pipe diameter to maintain proper delivery pressure, and a character home with a furnace, water heater and one or two fireplaces needs that total BTU input added up carefully.
CANRO measures the actual distance from meter to mechanical room, factoring in any detours needed around trees or landscaping the homeowner wants preserved, before recommending whether the existing line has room or needs upsizing.
A gas permit from the City of Burnaby applies to new lines and most modifications, with a pressure test and inspection required before an appliance can be connected. On larger, treed lots, the permit application sometimes needs to note tree protection zones near the planned route.
| Step | What happens | Handled by |
|---|---|---|
| Site walk | Distance, root systems and load reviewed | CANRO gas fitter |
| Permit | Filed with the City of Burnaby | CANRO office |
| Installation | Line routed around trees, pressure tested | CANRO gas fitter |
| Inspection | City sign-off before startup | City of Burnaby |
An isolated leak or a damaged fitting can typically be located with a pressure test and repaired at that specific point, without trenching the entire run through established gardens or root zones.
Where a full replacement is genuinely needed, CANRO discusses routing options that minimize disturbance to mature trees and landscaping the homeowner has invested years in, rather than defaulting to the shortest possible trench.
A visit starts with walking the property to understand the layout, the location of mature trees, and the distance from the meter to the mechanical room, before any trenching plan is put together.
CANRO's technicians hold a Technical Safety BC gas licence, so the finished work meets the standard a City of Burnaby inspector checks for, and the written scope reflects the property's actual layout rather than a generic estimate.
Safety note
Gas line installation, repair and pressure testing must be done by a Technical Safety BC licensed gas fitter, since a leaking or undersized line is a genuine safety hazard regardless of lot size. CANRO holds gas licence LGA0043870 and boiler licence LBP0046450. If you smell gas anywhere on the property, leave the area immediately and call FortisBC at 1-800-663-9911 from a safe distance.
Distance is one factor, and actual pricing depends on the measured run, pipe size and site conditions confirmed on a visit.
Usually yes, and CANRO plans the route with tree protection in mind wherever the layout allows it.
Multiple gas fireplaces plus a furnace and water heater can add up to more load than an older, smaller-diameter line was designed for.
Yes, and the application may need to note tree protection zones along the planned route.
A pressure test narrows down which section is losing pressure before any excavation is planned.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.