Replacing a furnace with one rated the same as the old one skips a step that often matters more than the brand: an actual load calculation.
Tell us what you need—we’ll call you back fast.
Quick answer
CANRO installs natural-gas Goodman furnaces for homeowners across Langley, and rather than simply matching the replacement furnace's output to whatever the old unit was rated for, we run an actual heat loss assessment of the home first. Furnaces installed years or decades ago were often sized generously by older rules of thumb, and replacing like-for-like can leave a homeowner with a furnace that short-cycles, runs noisily, or wastes energy compared with one sized to the home as it actually performs today.
Need a licensed gas fitter for your gas furnace? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
Furnace sizing practices have changed over the decades, and homes themselves change too, through added insulation, replaced windows, or renovations that alter how much heat a house actually loses on a cold day. A furnace that was correctly sized for a Langley home thirty years ago may now be considerably oversized for that same home if it has since been upgraded, or occasionally undersized if additions were made without revisiting the heating plan.
An oversized furnace short-cycles, turning on and off more often than it should, which wears out components faster and produces less even heat throughout the home. An undersized one runs constantly on cold days and never quite catches up.
| Situation | What Often Happens |
|---|---|
| Home has added insulation or new windows since original install | New furnace can often be sized smaller than the old one |
| Home has an addition without a heating review | New furnace may need to be sized larger, or zoning discussed |
| No changes since original construction | Replacement close to the original rating is often appropriate |
A correctly sized furnace connected to undersized or restrictive ductwork still will not perform as it should, so we check duct condition and general capacity as part of the same visit. This does not always mean new ductwork is needed; often it means confirming that what exists is adequate for the new equipment before we finalize the recommendation.
A residential natural-gas furnace installation in Langley, including a proper sizing assessment, typically falls in the range of $4,500 to $9,500 or more, as a ballpark, not a quote. Straightforward replacements with adequate existing infrastructure land toward the lower end; those needing ductwork adjustments to match a resized furnace can run higher. Our office confirms a firm number after the assessment.
CANRO is not an authorized or factory Goodman dealer, and we will not promise an exact efficiency rating or energy savings figure without documentation to support it. What we bring is an actual sizing assessment rather than an assumption based on the equipment that happened to be there before.
When you reach out, mention your home's approximate age and whether you have made any major upgrades like new windows or added insulation since it was built. That helps our technician prepare for a meaningful sizing assessment rather than a quick like-for-like quote.
Safety note
Furnace installation involves gas piping, venting, and combustion air requirements that must be handled by a Technical Safety BC licensed gas fitter; CANRO holds gas licence LGA0043870. If you smell gas near the installation area, leave the home and call FortisBC at 1-800-663-9911.
Homes change over time through insulation upgrades, new windows, or additions, and the old furnace's rating may no longer match what the home actually needs. A proper assessment avoids ending up with a furnace that short-cycles or underperforms.
It is an assessment of how much heat a home actually loses on a cold day, based on square footage, windows, insulation, and layout, used to size the replacement furnace correctly rather than guessing.
As a ballpark, not a quote, installations typically run $4,500 to $9,500 or more depending on sizing and any ductwork adjustments needed. Our office confirms a firm number after the assessment.
No, we are not an authorized or factory dealer for any single brand. We install and service furnaces across the major residential brands, including Goodman.
Not necessarily. We check existing duct capacity against the new furnace's requirements and only recommend changes where the ductwork would genuinely hold back performance.
Yes, it tends to short-cycle, turning on and off more frequently than it should, which wears components faster and produces less even heat than a correctly sized furnace.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.