What CANRO checks first on a KeepRite furnace repair call in downtown Langley City.
Tell us what you need—we’ll call you back fast.
Quick answer
A KeepRite furnace that's short-cycling, refusing to ignite, or running without much heat usually traces back to an ignition fault, a dirty flame sensor, or a restricted filter. CANRO diagnoses the specific cause on site and explains it before recommending any repair. Most calls resolve with a single part fix; a furnace with repeated failures or a major component down is the point where replacement is worth discussing honestly.
Need a licensed gas fitter for your gas furnace? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
The older core of Langley City, closer to the downtown commercial strip, has a good number of established single-family homes and older duplexes from past decades, many with original mechanical rooms that have seen more than one furnace over the years. KeepRite is a common brand among these older replacements, and CANRO's repair calls on the brand follow the pattern typical of most furnaces of a similar age: ignition and flame-sensing faults are the most frequent, followed by control board and blower issues.
Because a lot of these furnaces were installed a decade or more ago, CANRO also watches for signs the equipment is simply near the end of its useful life rather than treating every call as a quick single-part fix.
On an older duplex or single-family home downtown, it's also common for the mechanical room to have been shared or reconfigured at some point, sometimes with venting or wiring from a previous furnace still partially in place. CANRO checks the full setup rather than assuming the current configuration matches what a straightforward repair on a newer, more standard installation would look like.
| Symptom | Common cause |
|---|---|
| Furnace won't light | Failed ignitor, closed gas valve, or a tripped safety switch |
| Repeated short cycling | Dirty flame sensor or airflow restricted by a clogged filter |
| No response from thermostat | Blown control-board fuse or a wiring fault |
| Furnace runs longer than usual to heat the house | Aging blower motor or ductwork leakage |
| Rattling or vibration during operation | Loose panel, worn blower bearing, or a failing mount |
A number of the older homes closer to downtown Langley City have had one furnace running for well over a decade. When a major part fails on equipment that age, CANRO walks through the real repair cost against what a new installation would run, so the decision reflects the furnace's actual condition rather than an assumption either way.
If the furnace is still under any remaining manufacturer coverage, that's worth checking before deciding either way, since warranty terms and what they cover are set by the manufacturer and vary by model and purchase date. CANRO can help confirm what documentation exists for the unit, but the certificate itself is the final word on what's covered.
There's no flat repair price because it depends on the part that's failed and how accessible the furnace is inside the house. CANRO diagnoses on site and confirms an exact price before any repair begins.
Safety note
Furnace repair work on the burner and gas controls must be carried out by a Technical Safety BC licensed gas fitter; CANRO holds gas licence LGA0043870. If you smell gas at any point, leave the house immediately and call FortisBC at 1-800-663-9911.
Rattling is often a loose panel or a worn blower component. It's worth having checked before it develops into a bigger blower or motor issue.
Furnaces running well past a decade of service are more likely to need a major component eventually. CANRO assesses the specific unit rather than assuming based on age alone.
Yes, CANRO diagnoses and repairs KeepRite furnaces along with every other major brand in service across the Lower Mainland.
This can point to a weakening blower motor or duct leakage reducing delivered airflow. A technician can check both during a service call.
Yes, CANRO diagnoses the fault first and confirms an exact price before any repair work begins.
It depends on what's actually failed and the unit's overall condition. CANRO explains both options honestly so the decision is based on real information.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.