In Vancouver, a Noritz boiler repair usually costs a few hundred dollars, with older character homes sometimes adding to the labour.
Tell us what you need—we’ll call you back fast.
Quick answer
A Noritz boiler repair in Vancouver typically costs $250 to $1,800 in total, with most repairs settling around $400 to $900 once the $90 to $150 diagnostic call, parts and labour are combined. This is a 2026 public-market ballpark, not a quote for your specific home — CANRO's certified gas technicians confirm the exact price after inspecting your unit.
Need a licensed gas fitter for your gas boiler? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
A large share of Vancouver's east side and parts of the west side are built on pre-war and mid-century lots, including the classic Vancouver Special and older character homes with basement suites. Many of these houses still have older cast-iron radiator distribution even where the boiler itself has been updated over the years, and some retain chimneys that were part of the original heating system. Working around finished basement suites, low ceilings, or a boiler tucked into a shared laundry and mechanical space generally adds time to a repair compared with a wide-open mechanical room in newer construction.
| Item | Typical range (CAD) |
|---|---|
| Diagnostic / service call | $90–$150 (credited toward repair) |
| Gas technician labour | $95–$165 per hour |
| Full repair, parts and labour | $250–$1,800, most jobs $400–$900 |
The diagnostic fee covers a technician's time to properly trace a fault — checking ignition, flame sensing, water pressure, circulation and the control system's history — rather than swap parts and hope. That fee is usually credited toward the repair. From there, labour is billed at $95 to $165 per hour, with the total shaped by which part failed and how accessible the unit is.
A single failed component almost always favours repair over replacement, even in an older character home, as long as the rest of the system is functioning well. The calculation changes once a technician identifies a cracked heat exchanger, a control system that is increasingly hard to source parts for, or a pattern of repeat failures across one heating season — that is the point to ask directly for a repair-versus-replace comparison. Gas and venting work anywhere in the city requires a permit through the City of Vancouver, which your licensed technician handles as part of the job when it applies.
For a home with a basement suite, it's also worth clarifying with your technician whether a repeated fault is related to higher domestic hot water draw from the suite rather than a defect in the part itself. A boiler asked to do double duty for two households can wear certain components faster than one serving a single-family layout, which is useful context for both the repair and any future planning.
Vancouver's east side in particular has a high concentration of these dual-demand setups, so a technician working there will often ask directly about suite occupancy and usage patterns as part of a standard diagnostic conversation, rather than treating every home as a straightforward single-family install.
Safety note
If you smell gas near your boiler, notice soot around the cabinet, or see a flame that looks yellow instead of a clean blue, leave the house immediately and call FortisBC at 1-800-663-9911. Gas boiler work in BC must be performed by a Technical Safety BC licensed gas fitter; CANRO holds gas licence LGA0043870 and boiler licence LBP0046450.
Most repairs total $250 to $1,800, with the majority around $400 to $900 depending on the part and labour involved.
Often somewhat, since basement suites, low clearance, and original venting layouts can add labour time compared with a newer, open mechanical room.
Yes, it is typically applied to the repair total if you proceed with the work.
A single failure usually favours repair. Repeated failures or a major component like a heat exchanger are the signal to compare repair cost against a new install.
Access to the mechanical room is required, so scheduling around a tenant is common when the boiler serves a suite — your technician can help coordinate timing.
Basic parts replacement usually does not, but work touching gas piping or venting should be permitted through the City of Vancouver.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.