Licensed, Red Seal technicians — same-day response across Metro Vancouver. Call (604) 359-1081 or request a free quote.
Tell us what you need—we’ll call you back fast.
Selecting and servicing central A/Cs in Metro Vancouver involves several local factors — climate, available rebates, code requirements — covered below. Modern central A/C systems in Metro Vancouver run at 15-22 SEER2, with variable-speed inverter compressors that match output to load — eliminating the on/off cycling of older single-stage units.
Vancouver's mild winters (average lows above -5°C and rare deep cold snaps) shape equipment selection differently than colder Canadian cities. CANRO has worked with central A/C systems across Metro Vancouver since 1999, including installations and service calls in Lynn Valley, Eagle Ridge, Edgemont and Yaletown.
Sizing. A/C sizing in Vancouver is typically 1 ton per 600-1,000 square feet depending on insulation, windows, and orientation. Over-sized A/C is the most common error — it leads to short-cycling, poor dehumidification, and premature compressor failure.
Lifespan. A properly maintained central A/C unit lasts 12-15 years. Vancouver's coastal salt air shortens outdoor-coil life — annual coil cleaning is more important here than inland.
Warning signs. A/C issues include warm air from supply registers, water leaks from the indoor coil (clogged condensate drain), refrigerant odour (R-410A leak), and noisy compressor startup.
A/C sizing in Vancouver is typically 1 ton (12,000 BTU) per 600-1,000 sq ft depending on insulation, windows, and orientation. Over-sized A/C is the most common error — it short-cycles, dehumidifies poorly, and shortens compressor life.
R-410A is being phased down (not phased out) under EPA AIM rules. Existing R-410A systems can continue to be serviced — refrigerant remains available for the foreseeable future, though prices may rise. New systems installed 2025+ increasingly use R-32 or R-454B with lower global-warming potential.
Indoor water leaks from central A/C indicate a clogged condensate drain (most common), a failed condensate pump on attic installs, a frozen evaporator coil thawing, or a damaged drain pan. All are repairable in a single service visit.
Vancouver summers have been getting hotter — the 2021 heat dome saw temperatures over 40°C. Most modern Vancouver homes now install a heat pump (heating + cooling in one) rather than a stand-alone A/C, taking advantage of rebates available for heat pumps but not stand-alone A/C.
A typical 2.5-3 ton central A/C added to an existing forced-air furnace costs $5,500-$9,500 installed. A heat-pump conversion (cooling + heating in one unit) is usually a smarter long-term investment given available rebates.
Annual servicing in spring keeps the outdoor coil clean, the refrigerant charge correct, and the indoor evaporator coil and condensate drain clear. Skipping service is the single biggest cause of premature compressor failure.
To book central A/C service or get a free written quote for installation, call CANRO at (604) 359-1081 or email info@canroheat.ca. We service all of Metro Vancouver including Lynn Valley, Eagle Ridge, Edgemont and Yaletown.
This guide was written by the CANRO Heating & Cooling team based on 25+ years of central A/C installation, repair and annual service work across Metro Vancouver. Last reviewed May 2026.
“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.