Fraserview's postwar bungalows and newer rebuild homes each call for a different tankless sizing and venting approach, planned by CANRO.
Tell us what you need—we’ll call you back fast.
Quick answer
A gas tankless water heater in a Fraserview home needs sizing based on the household's peak hot water demand and a venting route confirmed for the home's specific layout, whether that's an original postwar bungalow with a compact basement or a larger rebuilt home with more bathrooms. A licensed technician assesses both before installation.
Need a licensed gas fitter for your hot water / boiler? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
Fraserview's original postwar bungalows are typically modest in size with one or two bathrooms, so a smaller tankless unit is often sufficient, while the neighbourhood's growing number of larger rebuilt homes near the river and golf course frequently have three or more bathrooms and correspondingly higher peak demand. A technician sizes each installation to the actual household rather than defaulting to the same unit across the neighbourhood.
| Home Type | Consideration | What We Check |
|---|---|---|
| Original bungalow, compact basement | Limited exterior wall clearance | Termination distance from windows, doors |
| Rebuilt home, larger mechanical room | More flexible vent routing | Standard clearance and gas capacity |
| Homes near the river | Site drainage and grade near termination | Condensate drain slope and placement |
Older bungalow gas lines sometimes need a section upsized to handle a tankless unit's higher peak draw compared to the smaller storage tank it's replacing, which is checked and quoted before installation. Rebuilt homes generally have gas infrastructure already sized for modern appliance loads.
A tankless installation in Fraserview typically falls in a ballpark of $3,500 to $7,500, with older bungalows needing gas line upsizing more likely to land toward the higher end. That's a ballpark, not a quote, confirmed after an in-person assessment.
Properties closer to the river and golf course sometimes have a slightly lower-lying mechanical room, so a technician also confirms the condensate drain from a condensing tankless unit has adequate slope and a clear path to daylight or a proper drain, since standing condensate can be a nuisance in a lower part of the home. This is a quick check but one that's easy to overlook if it's not specifically part of the installation plan.
Safety note
If you ever smell gas, hear hissing near the boiler or water heater, notice a yellow or flickering burner flame, soot around a draft hood, or a stale, headachy feeling near the mechanical room, leave the house immediately and call FortisBC at 1-800-663-9911 from somewhere safe. Gas piping, venting, and combustion appliances in BC must only be installed or serviced by a Technical Safety BC licensed gas fitter.
It can be, mainly for the space savings, though the household's actual hot water demand determines whether a smaller unit will comfortably keep up.
Often yes, since more bathrooms mean higher simultaneous demand; a technician sizes the unit to the household's peak use rather than the home's age.
Some older lines need upsizing to handle the higher peak draw; this is assessed and quoted before installation begins.
A straightforward swap can often be done in a day, while installs needing gas line work take longer.
Mainly through site drainage and condensate routing considerations, which a technician checks during the site visit.
Sometimes, depending on the home's plumbing layout and total peak demand; a technician can assess whether consolidating to one properly sized unit or keeping two units makes more sense.
A periodic descaling flush, typically every couple of years depending on household use, helps keep the heat exchanger performing well over the unit's service life.
Tankless units do have a fan and can produce some operating sound during firing, but properly installed units are generally not noticeably louder than a storage tank's burner cycling on.
A straightforward swap can often be finished in a day, while a job needing gas line upsizing takes longer to plan and complete.
No, removal and disposal of the old tank is included as part of the installation, so there's nothing for the homeowner to prepare beforehand.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.