Port Moody's hillside streets and older Glenayre homes shape what a Bosch boiler installation costs here.
Tell us what you need—we’ll call you back fast.
Quick answer
A new Bosch gas boiler installation in Port Moody runs roughly $6,500 to $14,000-plus, with a full boiler replacement closer to $7,500 to $15,000-plus. Those are 2026 ballpark figures built from current market data, not a fixed quote — CANRO's certified gas technicians confirm your actual cost after a short in-person assessment.
Need a licensed gas fitter for your gas boiler? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
Port Moody rises steeply from the head of Burrard Inlet, and homes in established areas like Glenayre and Heritage Mountain sit on grades that can complicate equipment access for a boiler installation. Older homes in this city, some dating to the mid-twentieth century, sometimes have mechanical rooms that need a fresh vent path or upgraded combustion air supply to accept a modern sealed-combustion Bosch boiler.
Newer construction closer to Moody Centre and along the flatter stretches near the waterfront tends to have mechanical rooms already built around direct-vent appliances, which keeps installation more straightforward — vent path and gas line sizing are usually already adequate.
| Scope | 2026 ballpark (CAD) |
|---|---|
| New Bosch boiler install | $6,500 – $14,000+ |
| Full boiler replacement | $7,500 – $15,000+ |
| Assessment / diagnostic visit | $90 – $150 |
| Licensed gas fitter labour rate | $95 – $165 per hour |
A boiler under ten years old with a single failed part is almost always cheaper and faster to repair than replace. The calculation shifts on older units common in Port Moody's established neighbourhoods, especially past the fifteen-year mark — once a major component like a heat exchanger is the suspected failure, a repair bill can start to approach what a new, more efficient installation would cost.
CANRO's technicians will assess your specific system's age and condition and give you a straight comparison rather than defaulting to either option.
Homeowners replacing a decades-old boiler in Port Moody are usually moving from a standing-pilot, lower-efficiency system to a modern condensing design, which changes more than just the venting. A condensing boiler modulates its output to match actual heating demand rather than cycling fully on and off, which tends to produce steadier, more even heat through the house and can reduce how hard the system works during shoulder-season weather.
That efficiency gain doesn't come with a specific dollar savings figure worth quoting, since actual gas usage depends on the home's insulation, size, and how the household uses heat, but it's a real factor in why many homeowners choose to replace rather than keep repairing an older standing-pilot boiler.
Every gas boiler installation here needs a Technical Safety BC gas permit from your licensed contractor and a mechanical permit through the City of Port Moody's building department, both closing with a final inspection. On hillside properties, confirm access arrangements with your contractor ahead of the inspection so scheduling isn't held up.
Given the number of older homes on this city's steeper streets, a careful look at existing venting and gas line routing during the assessment is what keeps the final invoice close to the initial estimate.
Safety note
If you smell gas or notice unusual venting odours near your boiler, leave the home immediately and call FortisBC's emergency line at 1-800-663-9911 from outside. Gas boiler installation in BC must be performed by a Technical Safety BC licensed gas fitter; CANRO holds gas licence LGA0043870 and boiler licence LBP0046450.
Sometimes, mainly due to access — steep driveways and multi-level lots in areas like Heritage Mountain can add labour time for moving equipment into the mechanical room.
Many older Port Moody homes were chimney-vented, and converting to a modern sidewall vent for a sealed-combustion Bosch boiler is a common part of the job on those properties.
Yes, CANRO typically applies the $90 to $150 diagnostic visit fee toward the final installation cost if you proceed.
A Technical Safety BC gas permit from your licensed contractor plus a mechanical permit through the City of Port Moody's building department, both closed with final inspection.
Under ten years old with one failed part, repair usually makes sense. Past fifteen years with a major component like a heat exchanger failing, compare that repair bill honestly against a new installation.
FortisBC and CleanBC programs for gas heating equipment exist and change over time, so confirm current eligibility with CANRO's office rather than assuming older terms apply.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.