Port Moody's hilly terrain around the head of Burrard Inlet creates a genuine mix of older Moody Centre homes and newer hillside construction.
Tell us what you need—we’ll call you back fast.
Quick answer
Hydronic and radiant floor heating uses a gas boiler to circulate hot water through in-floor tubing or baseboard radiators. Port Moody sits on hilly terrain wrapping around the head of Burrard Inlet, with older homes concentrated in Moody Centre and Glenayre and newer construction climbing the surrounding slopes, a mix that shapes whether a hydronic project centres on matching a boiler to existing radiators or designing an in-floor system from scratch.
Need a licensed gas fitter for your hot water / boiler? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
Moody Centre and the older streets closer to the inlet include homes dating back several decades, many with baseboard hot-water heating already installed from an earlier boiler generation. Newer construction on the hillside streets rising away from the water is more likely to have been built with in-floor radiant tubing from the outset, often across a walk-out lower level that takes advantage of the sloped lot.
Port Moody's location at the head of Burrard Inlet means a damp, coastal microclimate similar to much of the North Shore, with homes closer to the water seeing more direct exposure to rain and salt air than those higher up the slope. Any exterior vent terminal or condensate line benefits from being sited and sealed with that coastal exposure in mind, since persistent dampness accelerates wear at exterior penetrations over time.
| Home type | Typical approach |
|---|---|
| Older Moody Centre or Glenayre home | Boiler sized to match existing baseboard radiators |
| Newer hillside home with a walk-out lower level | In-floor tubing across multiple levels, zoned by level |
| Home close to the inlet with high moisture exposure | Extra attention to vent terminal sealing and placement |
Gas and mechanical permits for hydronic work go through the City of Port Moody's building department. The gas connection must be completed by a Technical Safety BC licensed gas fitter — CANRO holds gas licence LGA0043870 and boiler licence LBP0046450.
As a ballpark, not a quote, boiler installation supporting a hydronic system typically runs $6,500–$14,000+, with multi-level hillside homes needing more zones often landing toward the higher end. An in-home assessment accounts for your property's specific layout and exposure.
A number of Port Moody's hillside homes include a walk-out lower level that functions almost like a separate living space, sometimes as a suite. These levels tend to have a different heat loss profile than the main floor above, given more exposed exterior wall area, and are a good candidate for their own dedicated hydronic zone rather than being lumped in with the rest of the house.
Safety note
Hydronic and radiant systems are heated by a gas boiler, so the same rules apply as any gas appliance: leave the home and call FortisBC at 1-800-663-9911 if you ever notice a gas odour, soot, or a headache that eases outdoors. Gas fitting, venting, and boiler work must be done by a Technical Safety BC licensed gas fitter.
It increases moisture exposure at any exterior vent or condensate penetration, which is a reason to pay attention to sealing and placement, though it does not affect the heating system's core performance. A technician familiar with the local climate will typically use corrosion-resistant fittings and hardware at any exterior penetration as standard practice for homes in this setting.
Yes, and it is often a good idea, since a walk-out level typically has more exposed exterior wall area and a different heat loss profile than the main floor above it.
Yes, through the City of Port Moody's building department, and the gas connection must be completed by a licensed gas fitter.
In most cases yes, provided the replacement boiler is sized to match their output, which a technician confirms during an assessment.
Often yes, particularly for a walk-out level or renovated space, since it can be zoned independently from the rest of the house. Discuss the specific room's use and occupancy pattern with your installer, since that affects whether radiant heat or a supplementary source makes more sense.
As a ballpark, not a quote, expect $6,500–$14,000+, with multi-level hillside homes often toward the higher end depending on zoning needs.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.