Licensed, Red Seal technicians — same-day response across Metro Vancouver. Call (604) 359-1081 or request a free quote.
Tell us what you need—we’ll call you back fast.
Metro Vancouver homes have specific requirements when it comes to boilers, driven by climate, code, and the local housing stock. This page covers the essentials. Lennox is American (Iowa, 1895), best known for its SLP99V variable-capacity gas furnace (up to 99% AFUE) and the XC25 air conditioner. The brand's strengths are industry-leading variable-capacity modulation, premium build quality, top-rated for quiet operation.
BC's building code, TSBC gas-fitting rules, and FortisBC's natural-gas service standards together govern every HVAC installation in Metro Vancouver — CANRO works under permit and inspection on every gas-appliance install. CANRO has worked with Lennox systems across Metro Vancouver since 1999, from older retrofits in Norgate and Maple Ridge to new builds in Point Grey and Sullivan. Lennox is generally a strong fit for mid-to-upper Vancouver homes wanting maximum efficiency and the quietest possible system.
Sizing. Boiler sizing depends on heat-loss calculations (Manual J for the home + emitter capacity check). Oversized boilers short-cycle, which is the single biggest cause of premature heat-exchanger failure in Vancouver hydronic installs.
Lifespan. A well-maintained condensing boiler typically lasts 15-20 years in Vancouver. Cast-iron heritage boilers can run 30+ years, but their efficiency (60-75% AFUE) often makes replacement worthwhile after 20 years on energy savings alone.
Warning signs. A failing boiler typically shows kettling (banging or whistling at start-up), expansion-tank pressure loss requiring frequent top-ups, sooty combustion residue, persistent error codes, or radiators that no longer balance.
Over 25+ years of Lennox service calls across Metro Vancouver, the recurring issues we see are: flame-sensor fouling on older units, control-board failures on iComfort thermostats, blower-wheel ECM motor failures.
Parts availability. Lennox parts are dealer-network only — independent shops often struggle to source within 48 hours, but CANRO maintains a Lennox parts pipeline.
Pressure loss indicates either: an expansion tank that has lost its air charge, a leak somewhere in the loop (often a tiny pinhole behind a radiator or under flooring), a weeping pressure-relief valve, or a faulty automatic fill valve. CANRO uses pressure-decay testing and infrared imaging to locate hidden leaks.
Kettling is a banging or whistling sound caused by limescale build-up on the heat exchanger, which creates localised overheating spots. It will not always cause immediate failure but it shortens boiler life significantly and should be addressed within a few weeks by descaling and water-chemistry correction.
Annual servicing is recommended for all residential boilers in Metro Vancouver. The service includes combustion analysis, heat-exchanger inspection, expansion-tank pressure check, condensate-trap cleaning, circulator pump check, and a full safety inspection. Annual maintenance is also required to keep most manufacturer warranties valid.
A useful rule: if the boiler is more than 15 years old and the repair cost is more than 50% of replacement, replacement is the better long-term investment because newer units run at 95%+ AFUE vs 75-82% for older models — paying back the difference in energy savings over 6-10 years. CANRO gives you both quotes and lets you decide.
A typical residential high-efficiency gas boiler installation in Metro Vancouver costs $7,500-$15,000 depending on size, brand, and whether the system is heating-only or a combi unit also handling domestic hot water. Premium European brands (Viessmann, Baxi) sit at the upper end; North American brands (Navien, IBC, Rinnai) at the lower-middle.
A heating-only boiler heats only the hydronic loop (radiators, in-floor radiant, air-handler coil); a separate hot-water tank handles domestic hot water. A combi (combination) boiler heats both — eliminating the tank but requiring a higher-BTU boiler to handle peak DHW demand. Combi installs work best for 1-3 bathroom homes; heating-only + tank is usually better for 4+ bathroom homes.
To book Lennox boiler service or get a free written quote for installation, call CANRO at (604) 359-1081 or email info@canroheat.ca. We service all of Metro Vancouver including Norgate, Maple Ridge, Point Grey and Sullivan.
This guide was written by the CANRO Heating & Cooling team based on 25+ years of boiler installation, repair and annual service work across Metro Vancouver. Last reviewed May 2026.
“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.