A Rheem furnace installation in White Rock includes a proper home load calculation, permitted gas and venting work, and safe removal of the old unit, with a typical cost ballpark of $4,500 to $9,500 or more.
Tell us what you need—we’ll call you back fast.
Quick answer
Rheem's furnace lineup is widely installed across the Lower Mainland, often alongside the company's well-known water heaters in the same mechanical room. CANRO installs the furnace on its own merits, starting with a load calculation specific to the home rather than defaulting to whatever size the old furnace happened to be.
Need a licensed gas fitter for your gas furnace? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
Because Rheem also makes water heaters, some White Rock homeowners choose to replace both the furnace and the water heater at the same time, though each system is sized and installed independently.
Whether it's a furnace-only job or part of a bigger mechanical room refresh, sizing the furnace to the house is the first real step.
We calculate the home's actual heating load, remove the old furnace, install the new Rheem unit with permitted gas and vent connections, then run a full startup and combustion safety check.
If the water heater is being replaced at the same time, we coordinate both jobs so venting and gas supply are addressed together rather than twice.
As a ballpark, not a quote, a Rheem furnace installation in White Rock generally runs $4,500 to $9,500 or more depending on the model and any ductwork or venting changes required. Our office confirms the exact number after a short assessment.
White Rock runs its own building and gas permit process rather than going through Surrey, even though the two sit side by side on the Semiahmoo Peninsula, so scheduling a permitted job has to work around the city's own inspection windows.
Narrow older lots near the beach can leave very little room beside the house for a vent termination to meet the clearances the gas code calls for, which is something we check before quoting a repair or a replacement.
We handle the City of White Rock permit application and inspection scheduling as part of the job.
A full installation covers sizing, safe removal of the old furnace, all permitted connections, a complete safety check, and a plain walkthrough of the new system before we leave.
If you're already planning to replace a Rheem water heater, doing the furnace at the same time can mean a single, more efficient project rather than two separate visits months apart.
Either way, scheduling the work before the coldest part of the year gives us more flexibility and you more time to make a considered decision instead of a rushed one.
If you're replacing both a Rheem furnace and a Rheem water heater in the same project, clearing the full mechanical room ahead of time — not just around one appliance — helps the crew move through both jobs efficiently.
Expect the house to be without heat for part of the day during the swap, which we plan around if the forecast calls for colder weather.
Safety note
Furnace repair and installation work means opening up a natural gas appliance and its venting, and that isn't a homeowner job. If you ever smell gas anywhere near the furnace, leave the house first and call FortisBC's emergency line at 1-800-663-9911 from outside before doing anything else. Gas fitting in White Rock must be carried out by a Technical Safety BC licensed gas fitter.
Yes — many White Rock homeowners do both together, and we'll coordinate the venting and gas work so it's handled efficiently in one project.
As a ballpark, not a quote, roughly $4,500 to $9,500 or more depending on model and scope, confirmed exactly by our office after a short assessment.
Yes, the City of White Rock permit and inspection are included as part of the installation.
Through a load calculation based on your home's size, insulation, and layout, not by matching the old unit's rated output.
CANRO is an independent, licensed Metro Vancouver gas contractor that installs and services Rheem gas furnaces; check with Rheem directly for dealer-specific questions.
It's disconnected and removed safely as part of the installation.
Yes, they don't have to happen together — we can schedule either job on its own if that works better for your household.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.