Tempstar furnace installs in parts of Vancouver's lower-lying, historically wetter areas put extra weight on venting height and moisture protection.
Tell us what you need—we’ll call you back fast.
Quick answer
A Tempstar gas furnace installation in Vancouver generally falls in the $4,500 to $9,500+ ballpark, not a quote, with CANRO's office confirming the actual number after reviewing your specific home. Venting placement and crawlspace moisture get particular attention in some of Vancouver's lower-lying pockets, where historically wetter ground conditions mean a furnace or its venting needs a bit more thought than on higher, drier lots. Most installs complete in one working day when venting and gas supply don't need major rework.
Need a licensed gas fitter for your gas furnace? Call CANRO at (604) 359-1081 — residential natural-gas heating and hot water across Metro Vancouver since 1999.
A cracked or corroded heat exchanger ends the repair conversation outright on any brand. Beyond that, CANRO looks for a pattern of repeated, unrelated repairs, comfort complaints a repair hasn't resolved, and a furnace old enough that sourcing specific parts is becoming slower than it should be. Given that Tempstar is distributed through independent dealers, a furnace with an unclear service history sometimes tips the decision toward a fresh, fully documented installation rather than continuing to repair an unknown quantity.
Parts of Vancouver — areas near Marpole and other lower-lying pockets closer to the Fraser River — sit on ground that's historically wetter and can see more crawlspace moisture than higher, better-drained lots elsewhere in the city. For an installation in one of these areas, CANRO pays close attention to where the furnace sits relative to grade and how the condensate line drains, since a furnace installed low in a damp crawlspace without proper drainage consideration is setting up future problems rather than solving them.
$4,500 to $9,500+ is the ballpark, not a quote — the office confirms actual pricing after reviewing your job. A straightforward swap reusing existing venting sits toward the lower end. Venting relocation for drainage or clearance reasons, crawlspace work, ductwork repairs, and difficult access push the number higher. We flag which of these apply to your home before work starts.
Gas furnace installation in Vancouver requires a permit under the city's own building bylaw, separate from the provincial code most surrounding municipalities use. CANRO submits that application as part of the job. The gas connection is completed by a Technical Safety BC licensed gas fitter, and the finished installation is tested before it's signed off, regardless of which part of the city the work is in.
In a crawlspace install on lower ground, the exact placement of the furnace relative to the crawlspace's own drainage and any sump already in place is worth discussing before the unit is set, not after. Raising the furnace slightly on a properly built platform, keeping the condensate line pitched correctly toward its discharge point, and confirming the vent terminal sits high enough to clear seasonal water table changes are all small decisions made during the assessment that matter more over the following ten or fifteen years than they seem to on install day. Getting them right the first time avoids a service call down the road for a problem that traces back to placement rather than the furnace itself.
Safety note
Gas connections, venting, and final commissioning on a new furnace must be completed by a Technical Safety BC licensed gas fitter — CANRO holds gas licence LGA0043870. If you ever smell gas around a newly installed unit, leave the home immediately and call FortisBC's emergency line, 1-800-663-9911, from outside.
It can affect venting placement and crawlspace moisture management. CANRO assesses site conditions specifically for that during the installation planning.
Most jobs finish within a single working day when venting can be reused without major changes. Relocating venting or addressing crawlspace moisture can extend that.
Yes, the City of Vancouver requires a permit for gas furnace installation regardless of brand, and CANRO submits that application as part of the job.
The furnace, standard installation labour, and full commissioning. Venting relocation, crawlspace work, and difficult access are priced based on your specific site.
We can address drainage as it relates directly to the furnace and its venting or condensate line. Broader property drainage work falls outside a furnace installation.
Yes — venting is inspected as part of every installation rather than assumed to be adequate for the new furnace.
Family-run, TSBC-licensed (gas LGA0043870 · boiler LBP0046450), serving Metro Vancouver homes since 1999. Residential, natural gas only.
Call (604) 359-1081 Email info@canroheat.ca“Canro does an amazing job! Super professional and skilled with everything—boilers, furnaces, and AC. Always a pleasure working with them!”
“Five stars for Canro. We needed a replacement of a 30-year-old boiler. A new high-efficiency unit was installed—clean, professional work.”
“I can’t speak highly enough about George, who was recommended for a boiler service call for my parents’ home. George is excellent.”
25+ years keeping Metro Vancouver homes comfortable. Honest advice, upfront pricing, work that lasts.